Z-Com R2 Extender Guía de instalación Pagina 1

R2 Extender Quick Installation Guide V 1.0 January 2009 Page 1

Ground the Wire The R2 Extender is shipped with a grounding wire. The unit must be properly grounded to protect against power surges. The grounding p

Make sure PoE is correctly connected to the RJ-45 port on the R2 Extender labeled PoE+Data. DO NOT connect to the port labeled “Warning!! No POE

Chapter 4 Configuration Connect the R2 Extender to a Local Computer If you are configuring the R2 Extender locally (without connecting its power inje

Note: System ready R2 Extender’s still initializing Considering convenient configuration, it is recommended to configure local and remote R2 Exten

How to Establish Wireless Bridge Mode The R2 Extender supports four operating modes, which are Base Station, CPE, Peer-to-Peer (CSMA) and Peer-to-Pee

192.168.1.2 and set the IP Subnet Mask on both as 255.255.255.0 Warning: Each IP address is unique within a LAN, otherwise IP collision may occur

Login the Web-based interface of remote R2 Extender, open “About” in “System” and record the wireless MAC address of it, either WLAN 1 or WLAN 2 M

Warning: The MAC address on the housing of R2 Extender is the ETH MAC address; therefore it can not be used in Peer-to-Peer links. The IP addr

in “Wireless”. Select RF1 and hit “Align Antenna” button, an antenna alignment tool will popup. Specify the Target RSSI and click “Start” to begin th

Chapter 5 Troubleshooting This chapter provides troubleshooting procedures for basic problems with the R2 Extender. Q 1. What if my R2 Extender fai

Copyright Copyright © 2008 all rights reserved. No part of this publication may be reproduced, adapted, stored in a retrieval system, translated into

Chapter 6 Technical Support Page 20Chapter 6 Service Information If you have any further trouble using the R2 Extender or you would like to require

Chapter 1 Introduction Introduction The R2 Extender is a high-performance outdoor-deployable wireless bridge that provides wireless connectivity amo

Chapter 2 Preparation before Installation This chapter describes safety precautions and product information you have to know and check before install

Product Package The product package you have received should contain the following items. If any of them are not included or damaged, please conta

10. Wood Screw ×4 (for Wall Mount) 11. Wall/Gyprock Plug ×4 (for Wall Mount) Waterproof RJ-45 Connector Kit 1. Gland ×1 2. Sealing

Chapter 3 System Installation Assemble the Mounting Bracket 1. Place the main bracket into the seating and use a spanner to fasten the bracket to th

2. Fasten two M8×80 screws ○4 and washers ○5 through the drill holes and main bracket with a spanner; 3. Adjust the antenna for appropriate tilt

Connect Up Before installing the Ethernet cable with a waterproof RJ-45 connector, it is recommended that the Cat-5 RJ-45 coaxial cable be used for t